Egger Taupe Grey ST9 MFC – 2800×2070 mm – 18 mm

Egger Taupe Grey ST9 MFC

Bring a soft, warm mid tone into your interiors with Egger Taupe Grey ST9 melamine faced chipboard, stocked in our warehouse for delivery across Ireland. You get a balanced warm grey decor with a smooth ST9 matt face that leans understated rather than cool, faced both sides onto a stable chipboard core. At a full 2800 by 2070 mm and 18 mm thick, each sheet gives strong yield for cabinetry, and a colour matched ABS edging is available so the tone continues cleanly across every cut edge.

Why Egger MFC?

Melamine faced chipboard puts a finished, on trend surface at the core of your furniture without the extra paint and lacquer steps. The fused matt face is scratch and scuff resistant and wipes clean in seconds, so a mid grey stays even in kitchens, wardrobes and reception furniture. Factory pressed decor keeps the colour consistent from sheet to sheet, which matters on a neutral where any variation would read as a mismatch. The 18 mm core stays flat and stable for carcassing and shelving. As with all MFC, treat this as an interior board.

Installation guidance

Score the line first or use a fine tooth TCT blade and keep the sheet fully supported to protect the face during the cut. Assemble with confirmat screws, dowels or your usual cabinet fittings, which grip the core securely. Keep unsupported shelf spans sensible so an 18 mm board carries its load without bowing, and add a mid support on longer runs. Run the decor in the same orientation across paired parts so the matt face reads consistently through the finished unit.

Finishing & edge care

The faces come finished, so your work is at the edges. Seal every cut edge with our matching Taupe Grey ST9 ABS edging to close off the core and carry the warm tone from face to edge. Keep the board dry through storage and use, and treat it as an interior product only. Clean with a damp cloth and avoid abrasive pads and harsh solvents so the matt surface stays even.