Querkus Adagio MDF – 3050×1220 mm (10×4′) – 19 mm

Querkus Natura Adagio Oak Veneered Panel

Querkus Natura Adagio gives you the look of wide, crown cut solid oak running across a full sheet, without the cost, the movement or the waste of solid timber. It is a genuine oak veneered panel by Decospan, made from oak grown in well managed forests, with FSC (FSC-C095327) and PEFC (PEFC/07-32-60) certified stock available on request. Stocked in our warehouse for delivery across Ireland, it is the panel to reach for when a wall, a run of joinery or a shopfit has to read as real wood the moment someone walks in.

Why Querkus Natura Adagio?

Each Adagio face is made up of three crown cut boards, jointed with Decospan’s mixmatch technique so the grain never falls into the repeating, mirrored pattern that gives a cheap veneer away. Crown cut is the figure most people picture when they think of oak: broad cathedral arches with softer, flowing grain either side. Brushing lifts the harder grain so the surface has texture you can feel as well as see.

Behind that face, the panel is built to stay flat. Two layers of veneer are pressed to an 18 mm MDF core, the second layer acting as a balancer, for a finished thickness of 19 mm.

Every sheet in the range is composed the same way, so Adagio mixes and matches with the rest of Querkus. Panel a wall in Adagio, take an Allegro tone through the joinery, and the surfaces sit together instead of competing. No two panels are identical, which is exactly why a large elevation looks natural rather than printed.

Installation guidance

This is a decorative interior panel and it is not difficult to work, provided you respect the face. Let the sheets acclimatise flat in the room for at least 48 hours before cutting. Use a fine tooth blade, cut face up on a table saw or face down with a track saw, and support the full sheet so the offcut cannot drop and chip the veneer. Fix with panel adhesive and concealed fixings, and plan your sheet layout first so the board runs carry across joints.

Finishing & edge care

Natura is supplied raw, so the finish is your call. A clear hardwax oil or matt lacquer keeps the pale natural tone, while a white or grey pigmented oil holds off yellowing. Coat both faces and every cut edge, otherwise the panel takes up moisture unevenly and can bow. Go easy with abrasives: with only 0.6 mm to 1.5 mm of oak on the face, 180 to 240 grit by hand, with the grain, is as far as you should ever go. Matching edge banding, flex veneer and slats run right through the range, and we can order the edging to suit your sheets. Interior use only, away from standing water and direct sunlight.